Cisco Aironet 3800 Series - Mounting an AP Directly into the Tile Using Optional AIR-AP-BRACKET-3

Figure 16: AIR-CHNL-ADAPTER Mounted to Rail Clip (left) and Finished Installation (right)
When ordered, part numbers are replacement numbers so they end with an "=".Note
AIR-AP-T-RAIL-R=Ceiling Grid Clip–Recessed
AIR-AP-T-RAIL-F=Ceiling Grid Clip–Flush
AIR-AP-BRACKET-1=AP Bracket–Low Profile
AIR-AP-BRACKET-2=AP Bracket –Universal
AIR-CHNL-ADAPTER=Additional Adapter for Channel–Rail Ceiling Grid profile
Mounting an AP Directly into the Tile Using Optional AIR-AP-BRACKET-3
This bracket is not compatible with the AP 2800 and AP 3800 Series.Note
If you have this bracket currently installed and are migrating to the newer AP 2800 and AP 3800 series, you
may be able to still use the existing tile and leverage the new in-tile mount available from Oberon Wireless
(a Cisco partner).
Cisco Aironet Series 2800/3800 Access Point Deployment Guide
16
Physical Hardware and Mounting Options
Mounting an AP Directly into the Tile Using Optional AIR-AP-BRACKET-3