EasyManuals Logo

Cisco AP775A - Nexus Converged Network Switch 5010 Release Note

Cisco AP775A - Nexus Converged Network Switch 5010
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
Send documentation comments to nx5000-docfeedback@cisco.com
25
Cisco Nexus 5000 Series and Cisco Nexus 2000 Series Release Notes, Release 4.1(3)N1(1)
OL-16601-01
Caveats
CSCsq39683
Symptom: Fibre Channel links with traffic running on it might generate syslog errors such as the
following:
2008 May 21 15:08:55 switch %KERN-3-SYSTEM_MSG: FCP_ERRFCP_PORT:
gat_fcp_isr_process_blk_intr@1441, jiffies = 0xb1cec:ISR threshold reached, reg_block
= 0x8, num_regs = 6, idx = 0, src_bit = 11 - kernel
There is no loss in functionality and these messages can be ignored.
Workaround: None.
CSCso83662
Symptom: One global MAC address is used in all STP and PVRST frames originating on various
ports. This can result in inconsistent MAC moves on peer switches connected with multiple links.
Workaround: None.
Resolved Caveats—Cisco NX-OS Release 4.0(0)N1(1a)
This section lists the resolved caveats for this release.
CSCsq53614
Symptom: Ethernet port channels configured between two Cisco Nexus 5000Series switches cause
a memory leak in the DCBX process. This leak eventually leads to the DCBX process crashing and
a system reboot (in a few days). This issue occurs only with Ethernet port channels between Cisco
Nexus 5000 Series switches. Port channels using the Catalyst 6500 Series switches do not have this
problem.
Workaround: Disable receive and transmit Link Layer Discovery Protocol (LLDP) on the port
channel members by entering the following configuration under each Ethernet interface that is a
member of the port channel:
Interface Ethernet 1/1
no lldp receive
no lldp transmit
CSCsq36609
Symptom: For a virtual Ethernet or virtual Fibre Channel interface configured as a SPAN source,
changing the interface administrative state results in a memory leak. Deleting and adding SPAN
sessions also causes memory leaks. The memory leaks eventually cause a switch reboot.
Workaround: Avoid using virtual Ethernet and virtual Fibre Channel interfaces as SPAN sources.
Avoid deleting and adding SPAN sessions.
Resolved Caveats—Cisco NX-OS Release 4.0(0)N1(1)
This was the first release of Cisco NX-OS for Nexus 5000 Series switches. There are no resolved caveats
for this release.

Other manuals for Cisco AP775A - Nexus Converged Network Switch 5010

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco AP775A - Nexus Converged Network Switch 5010 and is the answer not in the manual?

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General IconGeneral
BrandCisco
ModelAP775A - Nexus Converged Network Switch 5010
CategorySwitch
LanguageEnglish

Related product manuals