EasyManuals Logo

Cisco ASA 5506-X Configuration Guide

Cisco ASA 5506-X
428 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #282 background imageLoading...
Page #282 background image
13-8
Cisco ASA Series Firewall CLI Configuration Guide
Chapter 13 Inspection of Basic Internet Protocols
FTP Inspection
Examples
The following example shows a how to use a new inspection policy map in the global default
configuration:
policy-map global_policy
class inspection_default
no inspect dns preset_dns_map
inspect dns new_dns_map
service-policy global_policy global
Monitoring DNS Inspection
To view information about the current DNS connections, enter the following command:
hostname# show conn
For connections using a DNS server, the source port of the connection may be replaced by the IP address
of the DNS server in the show conn command output.
A single connection is created for multiple DNS sessions, as long as they are between the same two
hosts, and the sessions have the same 5-tuple (source/destination IP address, source/destination port, and
protocol). DNS identification is tracked by app_id, and the idle timer for each app_id runs
independently.
Because the app_id expires independently, a legitimate DNS response can only pass through the security
appliance within a limited period of time and there is no resource build-up. However, when you enter the
show conn command, you see the idle timer of a DNS connection being reset by a new DNS session.
This is due to the nature of the shared DNS connection and is by design.
To display the statistics for DNS application inspection, enter the show service-policy command. The
following is sample output from the show service-policy command:
hostname# show service-policy
Interface outside:
Service-policy: sample_policy
Class-map: dns_port
Inspect: dns maximum-length 1500, packet 0, drop 0, reset-drop 0
FTP Inspection
The following sections describe the FTP inspection engine.
FTP Inspection Overview, page 13-8
Strict FTP, page 13-9
Configure FTP Inspection, page 13-10
Verifying and Monitoring FTP Inspection, page 13-14
FTP Inspection Overview
The FTP application inspection inspects the FTP sessions and performs four tasks:
Prepares dynamic secondary data connection

Table of Contents

Other manuals for Cisco ASA 5506-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASA 5506-X and is the answer not in the manual?

Cisco ASA 5506-X Specifications

General IconGeneral
ModelASA 5506-X
Firewall Throughput750 Mbps
Maximum Firewall Connections50, 000
Maximum VPN Peers50
Integrated Ports8 x 1 GE
Stateful Inspection Throughput750 Mbps
Weight4.4 lb (2 kg)
Firewall Throughput (Multiprotocol)750 Mbps
Firewall Throughput (Application Visibility and Control AVC)250 Mbps
Concurrent Sessions50, 000
New Connections per Second10, 000
IPsec VPN Throughput100 Mbps
Interfaces8 x 1 GE
Memory4 GB
Flash Memory8 GB
Form FactorDesktop
VPN Throughput100 Mbps
Maximum Concurrent Sessions50, 000
New Sessions per Second10, 000
Operating Temperature32 to 104°F (0 to 40°C)
Storage Temperature-13 to 158°F (-25 to 70°C)
Power SupplyExternal
Humidity10% to 90% non-condensing

Related product manuals