• Figure 55: Typical Source DC Power Cabling Scheme for a Single DC Power Module—Version 3 Power
System, on page 52 shows typical DC power source cable connections for a version 3 single DC power
module, in this case, a module installed in slot M3 of the power tray.
The DC power trays and power modules for the Cisco ASR 9000 Series Routers are identical, so the
examples shown in the below figures apply to all of these routers.
Note
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
50
Preparing for Installation
Site Requirement Guidelines
To Next Page
Loading...
