Cisco ASR 9000 Series - Page 64

PurposeCommand or Action
(Optional) Enters router IGMP or MLD configuration mode.router {igmp | mld}
Example:
RP/0/RSP0/CPU0:router(config)# router igmp
Step 5
(Optional) Configures the NSF timeout value for multicast
forwarding route entries under the IGMP process.
nsf lifetime seconds
Example:
RP/0/RSP0/CPU0:router(config-igmp)# nsf lifetime
Step 6
30
commit
Step 7
(Optional) Displays the state of NSF operation in IGMP.show {igmp nsf
Example:
RP/0/RSP0/CPU0:router# show igmp nsf
Step 8
(Optional) Displays the state of NSF operation for the MFIB
line cards.
show mfib [ipv4 | ipv6] nsf [location node-id]
Example:
RP/0/RSP0/CPU0:router# show mfib nsf
Step 9
(Optional) Displays the state of NSF operation in the MRIB.show mrib [ipv4 | ipv6] nsf
Example:
RP/0/RSP0/CPU0:router# show mrib nsf
Step 10
(Optional) Displays the state of NSF operation for PIM.show pim [ipv4 | ipv6] nsf
Example:
RP/0/RSP0/CPU0:router# show pim nsf
Step 11
Configuring Multicast VPN
•
Enabling a VPN for Multicast Routing, on page 66 (required)
• “Configuring BGP to Advertise VRF Routes for Multicast VPN from PE to PE” (required)
See the module “Implementing BGP on Cisco IOS XR Software in Cisco ASR 9000 Series Aggregation
Services Router Routing Configuration Guide.
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 5.1.x
64
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Configuring Multicast VPN