Cisco ASR 9000 Series - Page 69

PurposeCommand or Action
Configures the PIM rendezvous point (RP) address:
rp-address ip-address [group-access-list-name]
[bidir] [override]
Step 3
•
group-access-list-name = Specifies an access list of
groups to be mapped to a given RP.
Example:
RP/0/RSP0/CPU0:router(config-pim-vrf_A-ipv4)#
•
bidir = Specifies a bidirectional RP.
rp-address 10.0.0.0
•
override = Specifies that a static RP configuration should
override auto-RP and the bootstrap router (BSR).
commit
Step 4
Specifying the IGMP VRF Instance
SUMMARY STEPS
1.
configure
2.
router igmp
3.
vrf vrf-name
4.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enters IGMP configuration mode.router igmp
Example:
RP/0/RSP0/CPU0:router(config)# router igmp
Step 2
Configures a VRF instance.
vrf vrf-name
Example:
RP/0/RSP0/CPU0:router(config-igmp)# vrf vrf_B
Step 3
commit
Step 4
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 5.1.x
69
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Configuring Multicast VPN