Cisco ASR 9000 Series - Page 77

PurposeCommand or Action
Enters the address-family submode.address-family [ipv4 | ipv6 ]
Example:
RP/0/RSP0/CPU0:router(config-pim-vrf1)#
Step 22
address-family ipv4
Assigns a given routing policy to an RPF topology table.
rpf topology route-policy route_policy_name
Example:
RP/0/RSP0/CPU0:router(config-pim-vrf1-af)# rpf
Step 23
topology route-policy FOO
Takes the user to the global configuration mode.root
Example:
RP/0/RSP0/CPU0:router(config-pim-vrf1-af)# root
Step 24
Configures the route policy for a profile. For more
information about configuring route policy, see Cisco IOS
XR Routing Configuration Guide.
route-policy route_policy_name
Example:
RP/0/RSP0/CPU0:router(config)# route-policy
Step 25
FOO
Specifies the MDT type for the route policy.
set core-tree tree_type
Example:
RP/0/RSP0/CPU0:router(config-rpl)# set
Step 26
core-tree mldp-rosen
commit
Step 27
Verification of LSM mLDP based MVPN Configuration
Use these commands to verify the LSM mLDP based MVPN intranet configuration:
•
To check the MLDP neighbors, use the show mpls mldp neighbors command:
Router# show mpls mldp neighbors
mLDP neighbor database
MLDP peer ID : 1.0.0.1:0, uptime 15:36:30 Up,
Capabilities : GR, Typed Wildcard FEC, P2MP, MP2MP, MBB
Target Adj : No
Upstream count : 0
Branch count : 0
LDP GR : Enabled
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 5.1.x
77
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Configuring Multicast VPN