Cisco ASR 9000 Series - Page 86

SUMMARY STEPS
1.
configure
2.
interface type interface-path-id
3.
ipv4 address address mask
4.
exit
5.
router msdp
6.
default-peer ip-address [prefix-list list]
7.
originator-id type interface-path-id
8.
peer peer-address
9.
connect-source type interface-path-id
10.
mesh-group name
11.
remote-as as-number
12.
commit
13.
show msdp [ipv4] globals
14.
show msdp [ipv4] peer [peer-address]
15.
show msdp [ipv4] rpf rpf-address
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
(Optional) Enters interface configuration mode to define the
IPv4 address for the interface.
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface
Step 2
This step is required if you specify an interface type
and number whose primary address becomes the
source IP address for the TCP connection.
Note
loopback 0
(Optional) Defines the IPv4 address for the interface.
ipv4 address address mask
Step 3
Example:
RP/0/RSP0/CPU0:router(config-if)# ipv4
This step is required only if you specify an interface
type and number whose primary address becomes the
source IP address for the TCP connection. See optional
for information about configuring the connect-source
command.
Note
address 10.0.1.3 255.255.255.0
Exits interface configuration mode.exit
Example:
RP/0/RSP0/CPU0:router(config-if)# end
Step 4
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 5.1.x
86
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Interconnecting PIM-SM Domains with MSDP