Cisco ASR 9006 Unpacking And Installing

Figure 44: Removing a Line Card from the Cisco ASR 9912 Router Top Card Cage
Slide the card out of
the chassis.
3Pivot the ejector
levers outward to
unseat the card from
the backplane
connector.
2Loosen the captive
screws.
1
Step 4 Repeat Step 2 or Step 3 for each FC, LC, and RP card.
Rack-Mounting the Router Chassis
The router chassis is installed in a front-mounted position, as shown in the Telco 2-Post Rack section.
In a front-mounted position, the chassis rack-mounting flanges are secured directly to the rack posts.
The Cisco ASR 9922 Router and Cisco ASR 9912 Router are designed to mount in only 4-post racks.
Note
Unpacking and Installing the Chassis
48
Unpacking and Installing the Chassis
Rack-Mounting the Router Chassis

Cisco ASR 9006 Specifications

General

Chassis Type	Modular
Rack Units	10 RU
Slots	6
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Relative Humidity	5% to 95% non-condensing
Power Supply	AC or DC
Cooling	Front-to-back airflow
Input Voltage	100-240 VAC or -48 to -60 VDC
Supported Protocols	IPv4, IPv6, MPLS, L2VPN, L3VPN
Interfaces	10GE, 40GE, 100GE
Management Interfaces	Ethernet, Console, Auxiliary