EasyManuals Logo

Cisco ASR 903 Release Notes

Cisco ASR 903
280 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #135 background imageLoading...
Page #135 background image
53
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-08
Chapter
Caveats in Cisco IOS XE 3.7S Releases
CSCty79987
Symptoms: CFM up and down MEPs do not reach a scale of 1000 CFM sessions.
Conditions: Occurs when you configure CFM on a trunk EFP.
Workaround: There is no workaround.
CSCtz20087
Symptoms: The router applies the class-default QoS policy to all outgoing traffic.
Conditions: Occurs under the following conditions:
You configure multiple egress QoS policies on a Gigabit Ethernet interface.
You configure a multilink interface with no ingress QoS policy
Workaround: There is no workaround.
CSCtz32327
Symptoms: The router crashes.
Conditions: Occurs when you perform an OIR on the OC-3 IM after an SSO switchover.
Workaround: There is no workaround.
CSCtz40690
Symptoms: Traceroute to a remote MEP fails.
Conditions: Occurs under the following conditions:
You configure a EVC bridge-domain MEP on a remote device
You configure a MIP on a trunk EFP on an intermediate device.
You issue the traceroute command to the remote MEP
Workaround: There is no workaround.
CSCtz49927
Symptoms: Traffic floods on an EFP interface.
Conditions: Occurs when you configure a multicast static MAC on a bridge-domain and add more
than 24 EFPs.
Workaround: Remove the extra EFPs from the bridge-domain.
CSCtz55979
Symptoms: The router crashes.
Conditions: Occurs when you configure CFM, SCE over MPLS, VPLS, or G.8032 services while
running SNMP polling.
Workaround: There is no workaround.
CSCtz75641
Symptoms: The router does not pass traffic over an EVC PC port-channel.
Conditions: Occurs when you perform the following sequence of actions:
Remove an EVC member link from a port-channel interface
Configure a trunk EFP -Set the interface to default
Add the EVC member link back into the port-channel interface
Workaround: Reload the router.

Table of Contents

Other manuals for Cisco ASR 903

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 903 and is the answer not in the manual?

Cisco ASR 903 Specifications

General IconGeneral
Form FactorModular
Storage Temperature-40°C to 70°C (-40°F to 158°F)
Humidity5% to 95% non-condensing
RedundancyYes, redundant power supplies and route processors
Operating SystemCisco IOS XE
Power SupplyAC or DC
Switching Capacity240 Gbps
Operating Temperature-40°C to 65°C (-40°F to 149°F)
MTBF200, 000 hours
Supported ProtocolsIPv4, IPv6, MPLS, L2VPN, L3VPN
InterfacesGigabit Ethernet, 10 Gigabit Ethernet, T1/E1

Related product manuals