44
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-08
Caveats in Cisco IOS XE 3.9S Releases
–
ONS-SI-155-I1
Workaround: There is no workaround.
• CSCud27333
Symptom: The router crashes continuously.
Conditions: Occurs when you issue an interface module reset (OIR) while the standby RSP is
booting.
Workaround: Do not issue an interface module reset (OIR) while the standby RSP is booting.
• CSCud28982
Symptom: The router does not process egress CoS marking on an Ethernet service instance.
Conditions: Occurs when you configure QoS on an Ethernet service instance that is a member of a
bridge-domain and uses dot1q encapsulation.
Workaround: There is no workaround.
• CSCud29479
Symptom: The router stops applying QoS configurations.
Conditions: Occurs under the following conditions:
–
An Ethernet interface is configured with a single service instance
–
A QoS policy is attached to the service instance
–
The QoS policy contains a single class containing a match efp statement.
–
You reset the interface to the default configuration.
Workaround: There is no workaround.
• CSCud30806
Symptoms: Policy with class map match-all with prec 1 and prec 2 is accepted for WRED.
Conditions: match-all should not accept 2 prec values class-map match-all prec1_2 match
precedence 1 match precedence 2
Workaround: N/A
• CSCud33298
Symptom: The router crashes.
Conditions: Occurs when the peer device shuts down.
Workaround: There is no workaround.
• CSCud33906
Symptom: Equal Cost Multipath (ECMP) loopback does not function properly.
Conditions: Occurs when a port-channel link dynamically assigned as an ECMP path.
Workaround: There is no workaround.
• CSCud34346
Symptom: Nile manager crashes with the ECMP path when IPv4 scale is exceeded.
Conditions: This symptom occurs when scale is exceeded with the ECMP path.
Workaround: Do not allow the user to exceed the supported IPv4 route scale with ECMP.
• CSCud34600
To Next Page
Loading...
Need help?
General
