EasyManuals Logo
Home>Cisco>Network Router>ASR 903

Cisco ASR 903 Release Notes

Cisco ASR 903
280 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #250 background imageLoading...
Page #250 background image
8
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-08
Chapter
Caveats in Cisco IOS XE 3.10S Releases
Conditions: This issue occurs when maximum MPLS label of that template is assigned to that
prefix.
Workaround: Disable and enable the prefix.
CSCui40994
Symptom: Ethernet CFM ping fails because remote MEPs are not learnt.
Conditions: This issue occurs when MIP is configured on the same Vlan as MEP on the CFM
domain.
Workaround: Remove MIP configuration.
CSCui50577
Symptom: Traffic drops are observed on router.
Conditions: This issue occurs after performing an IM OIR.
Workaround: There is no workaround.
CSCui58365
Symptom: Router reboots while modifying a policy-map with class-map "match vlan 100".
Conditions: This issue occurs while attaching the "match vlan 100" egress policy-map. This issue
occurs after adding an ingress policy with no-match class and then adding an egress policy with
match on Vlan or dynamically adding match vlan class on egress policy.
Workaround: There is no workaround.
CSCui68159
Symptom: Traffic drops when two EFPs are configured on with default encapsulation and rewrite
push do1q on same BD.
Conditions: This issue occurs when two EFPs are configured on with default encapsulation and
rewrite push do1q on the same BD.
Workaround: There is no workaround.
CSCui87339
Symptom: Transceiver init_failure observed after transceiver OIR is performed.
Conditions: This issue is seen after the OIR of transceiver is performed.
Workaround: A slow OIR of transceiver might recover the port.
CSCui93830
Symptom: HQoS top level service-policy fails on the router when switching between the RSPs.
Conditions: This issue occurs when switching between the RSPs.
Workaround: Reattach the policy-map.
CSCuj07507
Symptom: High convergence for downstream traffic observed on the router.
Conditions: This issue occurs when VPLS VFI’s is controlled by g.8032 open ring, with a large
scale of about 500VC’s and 10000 MAC (40 per BD).
Workaround: Use small MAC scales for traffic.
CSCuj42080
Symptom: The FGPA gets stuck while pumping high volume of CFM packets.
Conditions: This issue occurs while pumping high volume of CFM packets on the router.

Table of Contents

Other manuals for Cisco ASR 903

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 903 and is the answer not in the manual?

Cisco ASR 903 Specifications

General IconGeneral
BrandCisco
ModelASR 903
CategoryNetwork Router
LanguageEnglish

Related product manuals