Cisco ASR 903 Release Notes

26
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-08
Chapter
Caveats in Cisco IOS XE 3.10S Releases
Symptom: The transmitting frequency is incorrectly displayed in the output of the show
hw-module subslot 0 transceiver idprom command.
Conditions: This issue is observed if you use DWDM-XFP-C modules.
Workaround: There is no workaround.
• CSCuh86102
Symptom: The interface stops forwarding traffic
Conditions: This issue is observed when the TenGigabitEthernet interface is in WAN-PHY mode
and R0 is active.
Workaround: Use R1.

Cisco ASR 903 Specifications

General

Form Factor	Modular
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 95% non-condensing
Redundancy	Yes, redundant power supplies and route processors
Operating System	Cisco IOS XE
Power Supply	AC or DC
Switching Capacity	240 Gbps
Operating Temperature	-40°C to 65°C (-40°F to 149°F)
MTBF	200, 000 hours
Supported Protocols	IPv4, IPv6, MPLS, L2VPN, L3VPN
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, T1/E1