Cisco ASR 903 Release Notes

24
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-08
Chapter Restrictions and Caveats in Cisco IOS XE 3.6S Releases
Caveats in Cisco IOS XE 3.6S Releases
Symptoms: The OC-3 interface module crashes when you perform multiple RSP switchovers.
Conditions: Occurs when the router is running a CEM configuration configured at full scale on all
ports and passing traffic.
Workaround: There is no workaround.
• CSCty51175
Symptoms: Serial interfaces configured with HDLC display false LOF or AIS alarms.
Conditions: Occurs when you configure a high volume of serial interfaces using HDLC.
Workaround: Remove and re-apply the serial interface configuration.
• CSCty51257
Symptoms: The T1/E1 interface module changes to inserted state during an in-service software
upgrade (ISSU), causing the interface to fail and the router to generate a core file.
Conditions: Occurs when you perform an in-service software upgrade (ISSU) on a router with a
T1/E1 interface module.
Workaround: Issue the shutdown command on the interface module before beginning ISSU; after
ISSU is complete, issue the no shutdown command on the interface module.
• CSCty51984
Symptoms: CEM circuits become inactive.
Conditions: Occurs when you perform an OIR, reload, or when you reconfigure a CEM circuit on
the router. The issue occurs more consistently when the router is running more than 300 CEM
circuits.
Workaround: Issue the clear xconnect all command.
• CSCty51990
Symptoms: The router may crash or restart; the console displays a
SW_WDOG: expired message.
Conditions: Occurs under the following conditions:
– The router is configured with 63 or more instances of a unique EVC configured with a unique
bridge domain interface (BDI).
– The router is sending IGMP joins to one multicast group.
– You perform a shutdown/no shutdown on the interface sending IGMP join messages.
– You perform an OIR on the router.
Workaround: There is no workaround.
• CSCty57746
Symptoms: The show environment command displays incorrect values, including P0 and P1
voltages, PSU status, PSU voltage, and critical alarms.
Conditions: Occurs when you apply the show environment command.
Workaround: There is no workaround.
• CSCty57751
Symptoms: The router crashes.
Conditions: Occurs under any of the following conditions:
– You perform an OIR on an interface module.
– You issue the no ppp multilink command on all MLP member links.

Cisco ASR 903 Specifications

General

Form Factor	Modular
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 95% non-condensing
Redundancy	Yes, redundant power supplies and route processors
Operating System	Cisco IOS XE
Power Supply	AC or DC
Switching Capacity	240 Gbps
Operating Temperature	-40°C to 65°C (-40°F to 149°F)
MTBF	200, 000 hours
Supported Protocols	IPv4, IPv6, MPLS, L2VPN, L3VPN
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, T1/E1