Cisco ASR 920 series

Contents
3
Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide
OL-32751-01
Preventing Power Loss 3-23
Activating a DC Power Supply 3-23
Activating an AC Power Supply 3-23
Connecting a Cisco ASR 920 Series Router to the Network 3-24
Connecting Console Cables 3-24
Connecting to the USB Serial Port Using Microsoft Windows 3-24
Connecting to the Console Port Using Mac OS X 3-27
Connecting to the Console Port Using Linux 3-27
Installing the Cisco Microsoft Windows USB Device Driver 3-28
Uninstalling the Cisco Microsoft Windows USB Driver 3-29
Connecting to the EIA Console Port 3-30
Connecting a Management Ethernet Cable 3-32
Installing and Removing SFP and SFP+ Modules 3-32
Connecting a USB Flash Device 3-32
Removing a USB Flash Device 3-33
Connecting Timing Cables 3-33
Connecting a Cable to the BITS Interface 3-33
Connecting Cables to a GPS Interface 3-34
Connecting Ethernet Cables 3-34
Connecting Cables to SFP Modules 3-35
Connector and Cable Specifications 3-35
CHAPTER 4 Cisco ASR 920 Series Aggregation Services Router Initial Configuration 4-1
Checking Conditions Prior to System Startup 4-1
Powering Up the Cisco ASR 920 Series Router 4-2
Verifying the Front Panel LEDs 4-6
Verifying the Hardware Configuration 4-6
Checking Hardware and Software Compatibility 4-6
Configuring the Cisco ASR 920 Series Router at Startup 4-7
Accessing the CLI Using the Console 4-7
Configuring Global Parameters 4-8
Checking the Running Configuration Settings 4-9
Saving the Running Configuration to NVRAM 4-9
Safely Powering Off the Cisco ASR 920 Series Router 4-9
CHAPTER 5 Troubleshooting 5-1
Pinouts 5-1
BITS Port Pinouts 5-1
Time-of-Day Port Pinouts 5-2