To Next Page

To Previous Page

5. FIND A PLACE TO STORE YOUR REMOTE

Keeping up with one remote is much easier than keeping up with four or ve remotes. However, it is

still a good idea to nd a storage location for your remote. The AT6400 is not a toy. It should be kept

out of the reach of children under the age of 6 years.

6. PROGRAM THE REMOTE TO CONTROL MY DEVICES

Your remote is initially programmed to only operate your Set Top Box. You will need to set up the

remote to operate your other devices using its TV, DVD, VCR, and AUX modes. The TV key may

be programmed to operate a standard or high-denition television (HDTV). The DVD key may

be programmed to operate a DVD player. The AUX key may be programmed to operate a VCR, a

receiver, an amplier, or a Home Theater in a Box (HTIB) system. If the remote provides only limited

functionality for a device, you can look for a code that provides more functionality. Refer to the code

tables at the end of this guide to locate additional programming codes.

Note: You have the option to assign some remote keys to operate one device type only. For example, you

may want to assign volume control to the TV only. If this is the case, you can reprogram power, volume,

and channel control using procedures found later in this guide.

7. ASSIGNING A DEVICE CODE TO A MODE KEY

Refer to the code tables at the end of this guide to locate the information for the device you want to

control.

NOTE: If your device is not listed, you may be able to program the remote using the Auto-Search

function. Go to What If None of the Codes Work on page 15 for instructions.

1. Turn on the device that you want to assign a mode key.

2. Press and hold the appropriate mode key (TV, DVD, or AUX) on the remote, and then press

and hold the OK key.

3. Release both keys and the mode keys blink twice.

4. Enter the rst 4-digit setup code for the device using the numeric keys (0-9) on the remote.

The mode key blinks three times to indicate that the code entry was accepted.

NOTES:

    • Whenaninvalidcodeisentered,theselectedmodekeydisplaysalongashtoindicate

that you have not entered the code correctly.

    • Shouldtheremotetime-outbeforeyoucompletethecodesetup,youmuststartover.

     ThisisindicatedbyonelongashoftheredLED.

UNIVERSAL REMOTE CONTROL

Cisco AT6400 User Manual

Other manuals for Cisco AT6400