To Next Page

To Previous Page

After you press the ENTER key, the channel key now controls the device associated with the mode

keyyouselect.Forexample,inTVmode,thechannelkeycontrolstheTV,butinSTBmode,the

channel key controls the Set Top Box.

NOTES:

 • Ifanyotherkeyispressed,excepttheModekeysandtheENTER key, the remote does not

accept any changes or updates. The STBmodekeydisplaysalongredashandtheremote

returns to normal operation.

 • Iftheremotetimesoutbeforeyoucompleteprogrammingchannelselectioncontrol,the

remote does not accept any changes. You must start over from step 1 of this procedure.

12. CHANGE POWER CONTROL

The POWER key on the remote is set by default to control the power switch on one device at a time,

in either mode (STB, TV, DVD, or AUX). When in STB mode, the remote switches the Set Top Box from

OFF (standby mode) to ON, or from ON to OFF (standby mode). However, you can alternatively

program the POWER key to control the power switch on up to four devices at the same time, instead

of controlling one device at a time. It is highly recommended that you set up the POWER key to turn

on and o your Set Top Box and your TV at the same time. Turning o the Set Top Box saves electricity

and extends the life of the box. When turned o, the Set Top Box can still record scheduled programs

on its DVR and perform any other necessary functions.

CONTROLLING POWER FOR MULTIPLE DEVICES AT ONCE (Program Code 977)

1. Press and hold the STB key on the remote.

2. Without releasing the STB key, press and hold the OK key.

3. Release both keys and all mode keys blink twice.

4. Enter the programming code 977 by pressing the numeric keys on the remote. The STB mode

key blinks twice to indicate a successful entry.

 5. Fortherstdevice,presstheSTB key. The STB mode key blinks twice.

 6. Fortheseconddevice,presstheapplicablemodekey(TV,DVD,orAUX).Theselectedmode

key blinks twice.

7. Repeat step 6 for up to two more devices (total of four devices).

8. Press the ENTER key to complete the power switch control programming. The last selected

mode key blinks 3 times to indicate a successful entry.

Example: If you press only TV in steps 6 and 7, the POWER key controls both the Set Top Box and the

TV at the same time, regardless of which mode the remote is in (STB, TV, DVD, or AUX).

CONTROLLING POWER FOR ONE DEVICE AT A TIME (Program Code 977)

Complete steps 1 through 4 of the Controlling Power for Multiple Devices at Once procedure.

Press the ENTER key to complete the power switch control programming. The last selected mode key

blinks 3 times to indicate a successful entry.

UNIVERSAL REMOTE CONTROL

Cisco AT6400 User Manual

Other manuals for Cisco AT6400