To Next Page

To Previous Page

Some common examples:

 • ToprogramtheAUX key to operate your DVD player, press DVD and then AUX.

 • ToprogramtheDVD key to operate your TV, press TV and then DVD.

10. CHANGE VOLUME CONTROL

By default, once the TV mode key is programmed with a valid code, the volume and mute buttons

control your TV. These keys adjust the volume of your TV higher, lower, or temporarily switch the

volume o (Mute), regardless of whether the remote is in STB, DVD, or AUX mode.

If you prefer, you can choose to have the volume and mute buttons always control a dierent device

rather than your TV, such as a home theater receiver. (See Controlling Volume for One Device

below.)Notethatyoumustrstprogramoneofthemodekeys,suchasAUX,withavalidcodefor

that device.

Alternatively, you can choose to have the volume and mute buttons control dierent devices

whentheremoteisindierentmodes.Forexample,youmightwanttocontrolthevolumeon

your TV when in TV mode, but the volume on your home theater receiver when in AUX mode. (See

Controlling Volume for Dierent Devicesbelow.)Notethatnotalldeviceshavevolumecontrols,so

if you choose this option, the volume and mute button may do nothing in some modes, such as STB

and DVD.

CONTROLLING VOLUME FOR ONE DEVICE (Program Code 955)

1. Press and hold the STB key on the remote control.

2. Without releasing the STB key, press and hold the OK key.

3. Release both keys and all mode keys blink twice.

4. Enter the programming code 955 by pressing the numeric keys on the remote. The STB key

blinks twice indicating a successful entry.

 5. Pressandreleasethemodekeyforthedeviceyouwantthevolumekeystocontrol.For

example, if you want to control volume through your TV, press and release TV. The selected

mode key blinks three times to indicate a successful entry.

6. The volume keys now control only one device whether you are in STB, TV, DVD, or AUX mode.

CONTROLLING VOLUME FOR DIFFERENT DEVICES (Program Code 955)

Complete steps 1 through 4 of the Controlling Volume for One Device procedure.

Press and release the ENTER key. The STB mode key blinks three times to indicate a successful entry.

UNIVERSAL REMOTE CONTROL

Cisco AT6400 User Manual

Other manuals for Cisco AT6400