Cisco ATA 191 User Manual

• 1512???1234—a call is forwarded to the corresponding destinatio if the phone number is an 11-digit
number starting with 1512 and ending with 1234
You can also forward the last call that you received, or block the last call.
Selective call forward is set up from the Voice tab of the Configuration Utility page. Use the information in
the following table to guide you. Once you have entered your settings, click Save to retain your revisions.
The following table describes the Call Forward settings that you configure from the Voice tab of the
Configuration Utility page.
Table 6: Selective Call Forward Settings
Usage GuidelinesDescriptionField Name
Enter the phone number that you
want redirected.
When a phone number matches the
entry, the call is forwarded to the
corresponding Cfwd Selective
Destination.
Call Forward Selective Caller
Default setting: blank
Cfwd Sel1-8 Caller
Enter the phone number that will
receive the forwarded call.
Call Forward Selective Destination
Default setting: blank
Cfwd Sel1-8 Dest
Enter the last caller's phone number.
This caller is actively forwarded to
the Cfwd Last Dest using Call
Forward Last.
Call Forward Last Caller
Default setting: blank
Cfwd Last Caller
The destination for the Cfwd Last
Caller.
Call Forward Last Destination
Default setting: blank
Cfwd Last Dest.
The number of the last caller; this
caller is blocked via the Block Last
Caller Service.
-
Default setting: blank
Block Last Caller
The number of the last caller; this
caller is accepted via the Accept Last
Caller Service.
-
Default setting: blank
Accept Last Caller
Speed Dial Settings
You can use specific phone lines to speed-dial people you call often.
Speed dials are set up from the Voice tab of the Configuration Utility page. Use the information in the following
table to guide you. Once you have entered your settings, click Save to retain your revisions.
The following table describes the Speed Dial settings that you configure from the Voice tab of the Configuration
Utility page.
Cisco ATA 191 and ATA 192 Analog Telephone Adapter User Guide for Multiplatform Firmware
16
Configure Features
Speed Dial Settings

Cisco ATA 191 Specifications

General

Fax Support	T.38 Fax Relay
Relative Humidity	10% to 90% (non-condensing)
Ports	2 FXS ports
Voice Protocol	SIP
Protocols	SIP, RTP, RTCP
Power	5V DC
Network Interfaces	10/100BASE-T Ethernet port
Operating Temperature	32°F to 104°F (0°C to 40°C)
Audio Codecs	G.711 (a-law and μ-law), G.729a, G.722, G.726
Voice Codecs	G.711 (a-law and μ-law), G.729a, G.722, G.726
Storage Temperature	14 to 140°F (-10 to 60°C)