Right-click the VM guest and click . The VM guest will take some time to
boot.
At the login prompt, enter the username , and the password .
At the Install Wizard prompt, type , and then press .
To enter IP information, follow the Install Wizard. Enter the following in the relevant fields.
Configure other entries as required.
Run Install wizard:
Do you wish to change the system password:
Password:
IP Protocol:
IP Address LAN1:
Subnet Mask LAN1:
Default Gateway Address:
Ethernet Speed:
Run ssh daemon:
The configuration is applied and TelePresence Conductor logs you out.
Log into TelePresence Conductor as root and then restart the VM guest by typing .
You should now be able to access TelePresence Conductor via a web browser.
To Next Page
Loading...
