Cisco Business Series Administration Guide

Security
SSH Client
348 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
17
SSH Client
See Security: SSH Client.
TCP/UDP Services
The TCP/UDP Services page enables TCP or UDP-based services on the device, usually for
security reasons.
The device offers the following TCP/UDP services:
• HTTP—Enabled by factory default
• HTTPS—Enabled by factory default
• SNMP—Disabled by factory default
• Telnet—Disabled by factory default
• SSH—Disabled by factory default
The active TCP connections are also displayed in this window.
To configure TCP/UDP services:
STEP 1 Click Security > TCP/UDP Services.
STEP 2 Enable or disable the following TCP/UDP services on the displayed services.
• HTTP Service—Indicates whether the HTTP service is enabled or disabled.
• HTTPS Service—Indicates whether the HTTPS service is enabled or disabled.
• SNMP Service—Indicates whether the SNMP service is enabled or disabled.
• Telnet Service—Indicates whether the Telnet service is enabled or disabled.
• SSH Service—Indicates whether the SSH server service is enabled or disabled.
STEP 3 Click Apply. The services are written to the Running Configuration file.
The TCP Service Table displays the following fields for each service:
• Service Name—Access method through which the device is offering the TCP service.
• Type—IP protocol the service uses.

Cisco Business Series Specifications

General

Brand	Cisco
Model	Business Series
Category	Switch
Language	English