Cisco Catalyst 2960-CX Manual

PurposeCommand or Action
Switch# show switch hstack-ports
(Optional) Saves your entries in the
configuration file.
copy running-config startup-config
Example:
Step 6
Switch# copy running-config
startup-config
Reloads the configuration.reload
Example:
Step 7
Switch# reload
What to do next
To convert a stack port into a network port, run the no switch switch-number hstack-port stack-port command:
Switch(config)# no switch 1 hstack-port 1 TenGigabitEthernet 1/0/1
Switch# copy running-config startup-config
Switch# reload
After configuration, restart the switch to convert the stack port into a network port.
Note
Stack port to network port conversion and vice versa cli is not nvgened. On write erase reload, the switch in
stack mode will not be converted to standalone, and manual conversion of stack port to network port is required.
Note
Enabling the Persistent MAC Address Feature
When you enter the command to configure this feature, a warning message appears with the consequences of
your configuration. You should use this feature cautiously. Using the old stack master MAC address elsewhere
in the same domain could result in lost traffic.
Note
Follow these steps to enable persistent MAC address:
Managing Switch Stacks
12
Managing Switch Stacks
Enabling the Persistent MAC Address Feature

Cisco Catalyst 2960-CX Specifications

General

PoE	No
DRAM	512 MB
MAC Address Table Size	16, 000 entries
Stacking	No
Model	Cisco Catalyst 2960-CX
Ports	8 x 10/100/1000 Ethernet ports
Uplink Interfaces	2 x 1G SFP
Power Input	100 to 240 VAC
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-25°C to 70°C (-13°F to 158°F)
Power Consumption	15W
Relative Humidity	10 to 95% noncondensing