Cisco Catalyst 2960-CX Manual

PurposeCommand or Action
If you enter the no stack-mac
persistent timer command after a
new stack master takes over, before
the time expires, the switch stack
moves to the current stack master
MAC address.
Note
Returns to privileged EXEC mode.end
Example:
Step 4
Switch(config)# end
(Optional) Saves your entries in the
configuration file.
copy running-config startup-config
Example:
Step 5
Switch# copy running-config
startup-config
What to do next
Use the no stack-mac persistent timer global configuration command to disable the persistent MAC address
feature.
Assigning a Stack Member Number
This optional task is available only from the stack master.
Follow these steps to assign a member number to a stack member:
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
• Enter your password if prompted.
Switch> enable
Enters global configuration mode.configure terminal
Example:
Step 2
Switch# configure terminal
Managing Switch Stacks
14
Managing Switch Stacks
Assigning a Stack Member Number

Cisco Catalyst 2960-CX Specifications

General

PoE	No
DRAM	512 MB
MAC Address Table Size	16, 000 entries
Stacking	No
Model	Cisco Catalyst 2960-CX
Ports	8 x 10/100/1000 Ethernet ports
Uplink Interfaces	2 x 1G SFP
Power Input	100 to 240 VAC
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-25°C to 70°C (-13°F to 158°F)
Power Consumption	15W
Relative Humidity	10 to 95% noncondensing