Cisco Catalyst 2960-CX Manual

PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Step 4
Switch(config)# end
(Optional) Saves your entries in the
configuration file.
copy running-config startup-config
Example:
Step 5
Switch# copy running-config
startup-config
Removing Provisioned Switch Information
Before you begin, you must remove the provisioned switch from the stack. This optional task is available
only from the stack master.
Procedure
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Step 1
Switch# configure terminal
Removes the provisioning information for the
specified member.
no switch stack-member-number provision
Example:
Step 2
Switch(config)# no switch 3 provision
Returns to privileged EXEC mode.end
Example:
Step 3
Switch(config)# end
(Optional) Saves your entries in the
configuration file.
copy running-config startup-config
Example:
Step 4
Switch# copy running-config
startup-config
Example
If you are removing a provisioned switch in a stack with this configuration:
• The stack has four members
Managing Switch Stacks
17
Managing Switch Stacks
Removing Provisioned Switch Information

Cisco Catalyst 2960-CX Specifications

General

PoE	No
DRAM	512 MB
MAC Address Table Size	16, 000 entries
Stacking	No
Model	Cisco Catalyst 2960-CX
Ports	8 x 10/100/1000 Ethernet ports
Uplink Interfaces	2 x 1G SFP
Power Input	100 to 240 VAC
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-25°C to 70°C (-13°F to 158°F)
Power Consumption	15W
Relative Humidity	10 to 95% noncondensing