17
Catalyst 2960-S Switch Getting Started Guide
OL-19793-02
Catalyst 2960-S Switch Getting Started Guide
This is an example of a redundant stack cable connection using both the 0.5- and
3-meter FlexStack cables.
Powering Guidelines
Consider these guidelines before you power the switches in a stack:
• If you want a particular switch to become the stack master, power on that
switch first. This switch becomes the stack master and remains the stack
master until a master reelection is required. After 2 minutes, power on the
remaining switches in the stack.
• Power off a switch before you add it to or remove it from an existing switch
stack.
For more information on stack master elections, see the “Managing Switch
Stacks” chapter in the switch software configuration guide on Cisco.com.
206230
To Next Page
Loading...
