Cisco Catalyst 2960X-48FPS-L User Manual

Description
Supported
Software
Image
Switch Model
24 10/100/1000 and 2 SFP+ module slots, 250-W power
supply.
IP LiteCatalyst 2960XR-24TD-I
1
48 10/100/1000 PoE+ ports (PoE budget of 740 W) and 4
SFP module slots, 1025-W power supply.
IP LiteCatalyst 2960XR-48FPS-I
1
48 10/100/1000 PoE+ ports (PoE budget of 370 W) and 4
SFP module slots, 640-W power supply.
IP LiteCatalyst 2960XR-48LPS-I
1
24 10/100/1000 PoE+ ports (PoE budget of 370 W) and 4
SFP module slots, 640-W power supply.
IP LiteCatalyst 2960XR-24PS-I
1
48 10/100/1000 and 4 SFP module slots, 250-W power supply.IP LiteCatalyst 2960XR-48TS-I
1
24 10/100/1000 and 4 SFP module slots, 250-W power supply.IP LiteCatalyst 2960XR-24TS-I
1
Front Panel
This section describes the front panel components:
•
24 or 48 downlink ports of one of these types:
◦
10/100/1000
◦
10/100/1000 PoE+
•
SFP ports
•
USB Type A connectors
•
USB mini-Type B (console) port
•
Ethernet management port
•
RJ-45 console port
•
LEDs
•
Mode button
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
OL-28309-02 3
Product Overview
Front Panel

Cisco Catalyst 2960X-48FPS-L Specifications

General

Device Type	Switch
Enclosure Type	Rack-mountable
Subtype	Gigabit Ethernet
Power Over Ethernet (PoE)	Yes
PoE Budget	740 W
Jumbo Frame Support	Yes
RAM	512 MB
Flash Memory	128 MB
Power Device	Internal power supply
Width	17.5 in
Model	Catalyst 2960X-48FPS-L
Ports	48 x 10/100/1000 PoE+
MAC Address Table Size	16000 entries
Routing Protocol	Static routing
Remote Management Protocol	SNMP 1, 2, 3, Telnet, SSH, CLI
Features	Layer 2 switching, VLAN support, QoS
Compliant Standards	IEEE 802.1Q, IEEE 802.1P, IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Status Indicators	Port status, PoE
Voltage Required	100 to 240 VAC
Operating Temperature	0 to 45 °C
Operating Humidity	10 - 95% (non-condensing)
Memory	512 MB RAM