Cisco Catalyst 2960X-48FPS-L User Manual

Step 5
When the InstallShield Wizard Completed window appears, click Finish.
Entering the Initial Configuration Information
To set up the switch, you need to complete the setup program, which runs automatically after the switch is
powered on. You must assign an IP address and other configuration information necessary for the switch to
communicate with the local routers and the Internet. This information is also needed to use Device Manager
or Cisco Network Assistant to configure and manage the switch.
IP Settings
Obtain this information from your network administrator before you start the setup program:
•
Switch IP address
•
Subnet mask (IP netmask)
•
Default gateway (router)
•
Enable secret password
•
Enable password
•
Telnet password
Completing the Setup Program
If your switches are stacked and there are multiple console connections to individual switches in the stack,
the initial setup dialog box appears at the console where you first press Enter.
Procedure
Step 1
Enter Yes at these two prompts:
Would you like to enter the initial configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system.
Would you like to enter basic management setup? [yes/no]: yes
Step 2
Enter a host name for the switch, and press Return.
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
OL-28309-02 89
Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information

Cisco Catalyst 2960X-48FPS-L Specifications

General

Device Type	Switch
Enclosure Type	Rack-mountable
Subtype	Gigabit Ethernet
Power Over Ethernet (PoE)	Yes
PoE Budget	740 W
Jumbo Frame Support	Yes
RAM	512 MB
Flash Memory	128 MB
Power Device	Internal power supply
Width	17.5 in
Model	Catalyst 2960X-48FPS-L
Ports	48 x 10/100/1000 PoE+
MAC Address Table Size	16000 entries
Routing Protocol	Static routing
Remote Management Protocol	SNMP 1, 2, 3, Telnet, SSH, CLI
Features	Layer 2 switching, VLAN support, QoS
Compliant Standards	IEEE 802.1Q, IEEE 802.1P, IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Status Indicators	Port status, PoE
Voltage Required	100 to 240 VAC
Operating Temperature	0 to 45 °C
Operating Humidity	10 - 95% (non-condensing)
Memory	512 MB RAM