Cisco Catalyst 2960X-48FPS-L User Manual

Attaching the Rack-Mount Brackets for the Catalyst 2960-X Switches
Procedure
Use two Phillips flat-head screws to attach the long side of the bracket to each side of the switch.
Figure 17: Attaching Brackets for 19-inch Racks
Mid-mounting position3Front-mounting position1
Rear-mounting position4Number-8 Phillips flat-head screws (48-2927-01)2
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
OL-28309-02 35
Switch Installation
Rack-Mounting

Cisco Catalyst 2960X-48FPS-L Specifications

General

Device Type	Switch
Enclosure Type	Rack-mountable
Subtype	Gigabit Ethernet
Power Over Ethernet (PoE)	Yes
PoE Budget	740 W
Jumbo Frame Support	Yes
RAM	512 MB
Flash Memory	128 MB
Power Device	Internal power supply
Width	17.5 in
Model	Catalyst 2960X-48FPS-L
Ports	48 x 10/100/1000 PoE+
MAC Address Table Size	16000 entries
Routing Protocol	Static routing
Remote Management Protocol	SNMP 1, 2, 3, Telnet, SSH, CLI
Features	Layer 2 switching, VLAN support, QoS
Compliant Standards	IEEE 802.1Q, IEEE 802.1P, IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Status Indicators	Port status, PoE
Voltage Required	100 to 240 VAC
Operating Temperature	0 to 45 °C
Operating Humidity	10 - 95% (non-condensing)
Memory	512 MB RAM