Cisco Catalyst 9800-L - User Manual

Installing the Cisco Catalyst 9800-L Wireless
Controller
This chapter describes how to install the Cisco Catalyst 9800-L Wireless Controller.
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work
on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents. Use the statement number provided at the end of each warning to locate
its translation in the translated safety warnings that accompanied this device. Statement 1071
Warning
SAVE THESE INSTRUCTIONS
• Mounting the Controller, on page 1
• Connecting the Controller Console Port, on page 12
• Management Ethernet Port Cable Connection, on page 12
• Installing a Security Lock, on page 13
Mounting the Controller
This section describes the various mounting options for the controller:
Mounting the Controller on Desktop or Shelf
Before mounting the controller on a desktop or shelf, install the rubber feet located in accessory kit shipped
with the controller.
To install the rubber feet to the controller, follow these steps:
Procedure
Step 1 Locate the rubber feet on the black adhesive strip that is shipped with the controller.
Installing the Cisco Catalyst 9800-L Wireless Controller
1

Cisco Catalyst 9800-L Specifications

General

Brand	Cisco
Model	Catalyst 9800-L
Category	Controller
Language	English

Summary

Mounting the Controller

Mounting the Controller on Desktop or Shelf

Instructions for attaching rubber feet to the controller for desktop or shelf placement.

Mounting the Controller on a Wall

Wall Mounting Procedure with Screws

Step-by-step guide for securely mounting the controller to a wall using screws.

Rack Mounting the Controller

Controller Rack Mounting Procedure

Detailed steps for installing the controller into a 19-inch equipment rack using the mounting tray.

Connecting the Controller Console Port

Console Port Connection Options

Covers connecting via RJ-45 console port or Micro USB console port, including driver notes.

Management Ethernet Port Cable Connection

Connecting the Management Ethernet Port

Procedure for connecting the controller's MGMT port to the network using an Ethernet cable.

Installing a Security Lock

Security Lock Installation

Information on using a Kensington lock to secure the controller via its back panel security slot.