Cisco Catalyst C9500-16X

CHAPTER 6
Installing Field Replaceable Units
• Installing a Power Supply , on page 61
• Installing a Fan Module, on page 80
• Installing an SSD Module, on page 87
Installing a Power Supply
Power Supply Overview
The switch chassis has two slots in which you can install power supplies using any of the following
combinations:
• Two AC, two DC or AC-DC power supplies
• One AC-input power supply or one DC-input power supply (leaving the blank cover on the other slot)
If you leave any power supply slots empty, you must ensure that the blank cover (Part Numbers
PWR-C4-BLANK, C9K-PWR-C4-BLANK, C9K-PWR-C5-BLANK and PWR-C6-BLANK) is installed in
that slot to maintain the designed airflow.
Note
This table lists the power supply models. To understand about the power supply modules supported on different
switch models, see Power Supply Slots, on page 21.
DescriptionPart Number
650W AC Power SupplyC9K-PWR-650WAC-R
650W AC Power SupplyC9K-PWR-650WACL-R
950W AC Power SupplyPWR-C4-950WAC-R
1600W AC Power SupplyC9K-PWR-1600WAC-R
930W DC Power SupplyC9K-PWR-930WDC-R
950W DC Power SupplyC9-PWR-950WDC-R
Cisco Catalyst 9500 Series Switches Hardware Installation Guide
61