Cisco Catalyst IW6300 Heavy Duty Series User Manual (English)

To Next Page

Installing the Access Point

This chapter describes how to install the access point.

• Mounting on a Wall or a Pole, on page 1

• Working with the Access Cover, on page 13

• Installing External Antennas, on page 15

• Grounding the Access Point , on page 19

• Using the Reset Button, on page 20

• Powering the Access Point, on page 20

• Performing Maintenance, on page 27

Mounting on a Wall or a Pole

This section provides instructions for the physical installation of your access points. Personnel installing the

access point must understand wireless access points and bridging techniques and grounding methods.

All installation methods for mounting an access point on any wall surface is subject to the acceptance of local

jurisdiction.

Caution

Installation Option

The Cisco Catalyst IW6300 Heavy Duty Series Access Points are installed using the pole mount installation

kit (IOT-ACCPMK), which is used for pole or wall installations.

Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement

1030

Warning

Installation of the equipment must comply with local and national electrical codes. Statement 1074

Warning

Refer to these sections for installation details:

Installing the Access Point

Need help?

Do you have a question about the Cisco Catalyst IW6300 Heavy Duty Series and is the answer not in the manual?

Cisco Catalyst IW6300 Heavy Duty Series Specifications

General