CHAPTER 2
Installation and Initial Configuration
This chapter describes how to initially install and configure your Cisco 3375 Appliance for Cisco Connected
Mobile Experiences.
This chapter contains these sections:
• Rack Warnings, on page 13
• Unpacking and Inspecting the Cisco CMX 3375, on page 14
• Preparing for Cisco CMX 3375 appliance Installation, on page 14
• Installing the Cisco CMX 3375 in a Rack, on page 17
• Initial Setup, on page 21
• NIC Modes, on page 26
• Configuring the CMX Software, on page 26
• Updating the BIOS and Cisco IMC Firmware, on page 28
• Accessing the System BIOS, on page 28
• Serial over LAN, on page 29
• Smart Access Serial, on page 29
• Smart Access USB, on page 30
Rack Warnings
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to
ensure that the system remains stable. The following guidelines are provided to ensure your safety: (1) This
unit should be mounted at the bottom of the rack if it is the only unit in the rack. (2) When mounting
this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component
at the bottom of the rack. (3) If the rack is provided with stabilizing devices, install the stabilizers before
mounting or servicing the unit in the rack. Statement 1006.
Warning
To reduce the risk of personal injury or equipment damage when unloading a rack, at least two people are
needed to safely unload the rack from the pallet.
Caution
Cisco 3375 Appliance for Cisco Connected Mobile Experiences Installation Guide
13
To Next Page
Loading...
