To prevent damage, ensure that water or excessive moisture cannot get into the Cisco CMX.
Caution
Unpacking and Inspecting the Cisco CMX 3375
The chassis is thoroughly inspected before shipment. If any damage occurred during transportation or any
items are missing, contact your customer service representative immediately.
To unpack the Cisco CMX 3375 appliance, follow these steps.
Before you begin
When handling internal Cisco CMX 3375 appliance components, wear an ESD strap and handle modules by
the carrier edges only.
Step 1 Remove the Cisco CMX 3375 appliance from its cardboard container and save all packaging material.
Keep the shipping container, in case the Cisco CMX 3375 appliance requires shipping in the future.
Note
Step 2 Check for damage and report any discrepancies or damage to your customer service representative. Have the following
information ready:
• Invoice number for shipper (see the packing slip)
• Serial number of the damaged unit
• Description of the damage
• Effect of damage on the installation
Preparing for Cisco CMX 3375 appliance Installation
This section provides information about preparing for Cisco CMX 3375 appliance installation, and it includes
the following topics:
Installation Warnings and Guidelines
Before you install, operate, or service a server, review the Regulatory Compliance and Safety Information for
Cisco UCS C-Series Servers for important safety information.
Note
Cisco 3375 Appliance for Cisco Connected Mobile Experiences Installation Guide
14
Installation and Initial Configuration
Unpacking and Inspecting the Cisco CMX 3375
To Next Page
Loading...
