Table 8: 1050 W DC Specifications
SpecificationDescription
Nominal range: -48 to -60 VDC
(Range: -40 to -72 VDC)
DC Input Voltage
32 A at -40 VDCMaximum DC input current
1234 WMaximum input wattage
35 A (sub-cycle duration)Maximum inrush current
5 ms at 100% load (1050 W main and 36 W standby)Maximum hold-up time
1050 W on 12 VDC main power
36 W on 12 VDC standby power
Maximum output power per PSU
12 VDCPower supply output voltage
12 VDCPower supply standby voltage
≥ 92% at 50% loadEfficiency rating
RSP2Form factor
Fixed 3-wire blockInput connector
Power Cord Specifications
Each power supply in the server has a power cord. Standard power cords or jumper power cords are available
for connection to the server. The shorter jumper power cords, for use in racks, are available as an optional
alternative to the standard power cords.
Only the approved power cords or jumper power cords listed below are supported.
Note
Table 9: Supported Power Cords
Length
(Meters)
Length
(Feet)
Description
3.511.7CAB-48DC-40A-8AWG
DC power cord, -48 VDC, 40 A, 8 AWG
Three-socket Mini-Fit connector to three-wire
3.09.8CAB-C13-C14-AC
AC power cord, 10 A; C13 to C14, recessed receptacle
Cisco 3375 Appliance for Cisco Connected Mobile Experiences Installation Guide
43
Technical Specifications
Power Cord Specifications
To Next Page
Loading...
