Getting Started
This section describes how to use the D9800 Network Transport Receiver front panel and web GUI, as well
as how to initially set up the D9800 receiver. There are two ways to configure the D9800 unit: front panel
and web GUI. For example, changes made through the front panel is reflected on the web GUI, and vice
versa.
•
About the Front Panel, page 1
•
Logging on to the D9800 Web GUI, page 7
•
Basic Vs. Advanced Mode, page 10
•
Quick Setup, page 10
About the Front Panel
You can use the controls and indicators on the front panel to operate the D9800 receiver. These include the
numeric keypad, the navigation or selection keypad, the LCD, the alarm and signal indicators. These are
shown in the following illustration.
Figure 1: D9800 Front Panel
LCD
The LCD provides information on the selections available at any menu level, current settings for parameters,
and certain status and alarm indications. This is a 2x40, backlit LCD display. The top line may be status data
Cisco D9800 Network Transport Receiver Version 3.11 Installation and Configuration Guide
1
To Next Page
Need help?
General
