Cisco D9800 Getting Started

Auto-Refresh
The system automatically refreshes the Summary Dashboard page every minute. Click Auto Refresh: On/Off
to toggle between enabling or disabling the automatic refresh feature.
Basic Vs. Advanced Mode
All the D9800 features are available in the Advanced mode (default). However, you have the option of limiting
the features available by switching to the Basic mode. The mode option is available at the top right-hand
corner of the D9800 web GUI.
The switch affects all pages, not only the current page.Note
The following is a list of features that are NOT included in the Basic mode:
•
AFC Limit, Input Selection, Polarisation, Orbital Posn, and East/West Flag options in RF Input Selection
area of the RF Input Setup page.
•
Orbital Validation Status and Orbital Validation Date status fields in the Tuner Performance area of
the RF Input Setup page.
•
Muting Threshold, Disaster Recovery, Disaster Recovery Status, Channel Selection, Cue Tone
(single-stream only), and Decode Enable (single-stream only) menu options.
•
CI Component Setup in CI Setup page.
Quick Setup
The following table provides the most common tasks to initially configure the D9800 Network Transport
Receiver.
DescriptionTask
Set up the network connection.Setting up the Network Connection
Acquire and configure one of the following inputs:
RF, ASI, IP, or ABR.
Tuning to an RF Input, Tuning to the ASI Input,
Tuning to the MPEGoIP Input, or Tuning to the ABR
Input
Cisco D9800 Network Transport Receiver Version 3.11 Installation and Configuration Guide
10
Getting Started
Basic Vs. Advanced Mode

Cisco D9800 Specifications

General

Brand	Cisco
Model	D9800
Category	Receiver
Language	English