Cisco D9800 Getting Started

DescriptionTask
Assign a program channel to a program entry.Assigning a Channel to a Program Entry
Set the following ASI output parameters:
•
Output Mode - We recommend to set it to MAP
Service Channels Only. Select Yes if requested
to Resync All.
•
Descramble Mode
•
Insert Null Packet - Set to Yes.
Configuring the ASI or MPEGoIP Output General
Settings and Configuring the ASI or MPEGoIP Output
Mode
Choose the SDI1 and SDI2 outputs. The SDI outputs
are only available on units with the SDI option
installed (D9800-3G-SDI).
Configuring the SDI Outputs
Configure the MPEG over IP output and stream
settings. The MPEGOIP outputs are only available
on units with the MPEGOIP input/output option
installed (D9800-SS-MPEGOIP).
For multi-stream units (D9800-MS-MPEGOIP),
configure the IP data output and stream settings.
Configuring the ASI or MPEGoIP Output General
Settings and Configuring MPEG over IP or IP Data
Streams
Set the DPM mode.Typical Digital Program Mapping Setup
Cisco D9800 Network Transport Receiver Version 3.11 Installation and Configuration Guide
11
Getting Started
Quick Setup

Cisco D9800 Specifications

General

Brand	Cisco
Model	D9800
Category	Receiver
Language	English