Cisco Firepower 1100 Series

connect a new Firepower 1100 to a network so that the IT department can on board the device to CDO and
configure it remotely. CDO supports Firepower Threat Defense (FTD) version 6.7 and later.
The following figure shows the QR code sticker.
Figure 3: QR Code Sticker
The following figure shows the placement of the QR code sticker on the rear panel of the chassis.
Figure 4: QR Code Sticker on the Chassis
—QR code sticker1
Serial Number Location
You can view the serial number and additional model information on the compliance label located on the
bottom of the chassis. The following figure shows a sample compliance label.
Cisco Firepower 1100 Series Hardware Installation Guide
7
Overview
Serial Number Location