EasyManuals Logo

Cisco Firepower 1100 Series Hardware Installation Guide

Cisco Firepower 1100 Series
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
Statement 1005—Circuit Breaker
This product relies on the building's installation for short-circuit (overcurrent) protection. To reduce risk of
electric shock or fire, ensure that the protective device is rated not greater than: 20 A, 120 V, and 16 A, 250
V
Warning
Statement 1015—Battery Handling
To reduce risk of fire, explosion or leakage of flammable liquid or gas:
Replace the battery only with the same or equivalent type recommended by the manufacturer.
Do not dismantle, crush, puncture, use a sharp tool to remove, short external contacts, or dispose of the
battery in fire.
Do not use if battery is warped or swollen.
Do not store or use battery in a temperature > 60° C.
Warning
Statement 1017Restricted Area
This unit is intended for installation in restricted access areas. Only skilled, instructed, or qualified personnel
can access a restricted access area.
Warning
Statement 1021SELV Circuit
To avoid electric shock, do not connect SELV circuits to telephone-network voltage (TNV) circuits. LAN
ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and WAN ports both use
RJ-45 connectors. Use caution when connecting cables.
Warning
Statement 1024Ground Conductor
This equipment must be grounded. To reduce the risk of electric shock, never defeat the ground conductor or
operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical
inspection authority or an electrician if you are uncertain that suitable grounding is available.
Warning
Statement 1029Blank Faceplates and Cover Panels
Blank faceplates and cover panels serve three important functions: they reduce the risk of electric shock and
fire, they contain electromagnetic interference (EMI) that might disrupt other equipment, and they direct the
flow of cooling air through the chassis. Do not operate the system unless all cards, faceplates, front covers,
and rear covers are in place.
Warning
Cisco Firepower 1100 Series Hardware Installation Guide
20
Installation Preparation
Installation Warnings

Other manuals for Cisco Firepower 1100 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Firepower 1100 Series and is the answer not in the manual?

Cisco Firepower 1100 Series Specifications

General IconGeneral
BrandCisco
ModelFirepower 1100 Series
CategoryFirewall
LanguageEnglish

Related product manuals