Statement 1030—Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1073—No User-Serviceable Parts
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Warning
Statement 1089—Instructed and Skilled Person Definitions
An instructed person is someone who has been instructed and trained by a skilled person and takes
the necessary precautions when working with equipment.
A skilled person or qualified personnel is someone who has training or experience in the equipment
technology and understands potential hazards when working with equipment.
Warning
Statement 1090—Installation by Skilled Person
Only a skilled person should be allowed to install, replace, or service this equipment. See statement
1089 for the definition of a skilled person.
Warning
Statement 1091—Installation by an Instructed Person
Only an instructed person or skilled person should be allowed to install, replace, or service this
equipment. See statement 1089 for the definition of an instructed or skilled person.
Warning
Step 1 To remove the Supervisor, loosen the two captive screws on the Supervisor tray.
Step 2 Remove the Supervisor tray from the chassis by pulling the handle on the Supervisor until it is unseated.
Step 3 Slide the tray partway out of the chassis, place your other hand under the tray to support its weight, and remove it from
the chassis.
Installation, Maintenance, and Upgrade
2
Installation, Maintenance, and Upgrade
Remove and Replace the Supervisor