a) Power up the chassis so that the new network module is recognized (if the new network module does not support hot
swapping).
b) Bring the new network module online using the appropriate CLI command (if the new network module supports hot
swapping). The saved network module configuration is automatically reapplied when the network module is back
online.
If you install a network module that is a different PID than the original network module, the saved
configuration is deleted and the default configuration is applied. You must enter the acknowledge command
to confirm the network module PID change.
Note
Follow the procedures in the FXOS Configuration Guide to connect to the network module and make sure that it has
been discovered correctly by the Firepower 9300.
Install, Remove, and Replace the Double-Wide Network Module
This procedure describes how to install a network module into an empty slot that has never contained a network
module, and how to remove an installed network module and replace it with another network module.
Make sure your Firepower 9300 has the correct firmware package installed before you install the
Firepower 100-Gb network module. For instructions on how to verify your firmware package version
and to upgrade the firmware if necessary, see the Cisco Firepower 4100/9300 FXOS Firmware Upgrade
Guide.
Note
The Firepower 100-Gb network module is an optional, removable I/O module that provides two fiber 100
Gigabit Ethernet interfaces. It takes up two slots in the Firepower 9300 and supports single and multimode.
Verify that your software supports hot swapping. See Cisco Firepower 4100/9300 FXOS Compatibility for
the software compatibility matrix. After removing and replacing the network module, you must reboot the
system so that the Firepower 9300 discovers the new network module. See Network Modules for more
information about Firepower 9300 network modules.
The following figure shows the front panel view of the Firepower 9300 100-Gb network module.
Installation, Maintenance, and Upgrade
13
Installation, Maintenance, and Upgrade
Install, Remove, and Replace the Double-Wide Network Module
To Next Page
Loading...
