If you want to replace an existing security module with another security module, you must decommission
the old security module before removing it. See the "Security Module/Engine Management" chapter in
the Cisco FXOS Firepower Chassis Manager Configuration Guide for the instructions. After you
decommission the old security module, you can remove it, install the new security module, have the
system acknowledge it, and then reinitialize it.
Caution
Safety Warnings
Take note of the following component replacement safety warnings:
Statement 1028—More Than One Power Supply
This unit might have more than one power supply connection. To reduce risk of electric shock,
remove all connections to de-energize the unit.
Warning
Statement 1030—Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1073—No User-Serviceable Parts
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Warning
Statement 1089—Instructed and Skilled Person Definitions
An instructed person is someone who has been instructed and trained by a skilled person and takes
the necessary precautions when working with equipment.
A skilled person or qualified personnel is someone who has training or experience in the equipment
technology and understands potential hazards when working with equipment.
Warning
Statement 1090—Installation by Skilled Person
Only a skilled person should be allowed to install, replace, or service this equipment. See statement
1089 for the definition of a skilled person.
Warning
Installation, Maintenance, and Upgrade
4
Installation, Maintenance, and Upgrade
Install, Remove, and Replace the Security Module
To Next Page
Loading...
Need help?
General
