Cisco Firepower 9300 Installation & Maintenance

Verify that you have the correct ROMMON on the Supervisor to support hot swapping. For
instructions on how to verify your firmware package version and to upgrade the firmware if
necessary, see the Cisco Firepower 4100/9300 FXOS Firmware Upgrade Guide.
Note
To remove and replace the network modules that do not currently support hot swapping, power off the chassis,
replace the network module, and then power the chassis back on.
Verify that you have the correct ROMMON on the Supervisor to support the 100-Gb network modules
(FPR9K-NM-4X100G and FPR9K-NM-2X100G). For instructions on how to verify your firmware
package version and to upgrade the firmware if necessary, see the Cisco Firepower 4100/9300 FXOS
Firmware Upgrade Guide.
Note
The following figure shows the front panel of the 10-Gb nonhardware bypass network module. The location
of the captive screw, ports, and LEDs is shown. See Network Modules for more information about the other
single-wide network modules.
Figure 4: Firepower Network Module 10 Gb
Ethernet X/12Captive screw/handle1
Ethernet X/54Ethernet X/33
Ethernet X/26Ethernet X/75
Ethernet X/68Ethernet X/47
Network activity LEDs
• Off—No connection or port is not in use.
• Amber—No link or network failure.
• Green—Link up.
• Green, flashing—Network activity.
10Ethernet X/89
Installation, Maintenance, and Upgrade
9
Installation, Maintenance, and Upgrade
Install, Remove, and Replace the Single-Wide Network Module

Cisco Firepower 9300 Specifications

General

Chassis	Modular
Security Modules	Up to 3
Firewall Throughput	Up to 1.2 Tbps
Management	Cisco Firepower Management Center
Form Factor	Rack-mountable
Number of Slots	3
Encryption Throughput	Up to 100 Gbps
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Altitude	Up to 10, 000 ft
Power Supply	Dual, hot-swappable
Product Type	Security Appliance
Supported Modules	Security, network, and interface modules
Redundancy	Yes