Step 4 Click Save.
Configure NAT
A typical NAT rule converts internal addresses to a port on the outside interface IP address. This type of NAT
rule is called interface Port Address Translation (PAT).
Procedure
Step 1 Choose Devices > NAT, and click New Policy > Threat Defense NAT.
Step 2 Name the policy, select the device(s) that you want to use the policy, and click Save.
The policy is added the management center. You still have to add rules to the policy.
Step 3 Click Add Rule.
The Add NAT Rule dialog box appears.
Step 4 Configure the basic rule options:
• NAT Rule—Choose Auto NAT Rule.
Cisco Firepower 1010 Getting Started Guide
38
Threat Defense Deployment with the Management Center
Configure NAT
To Next Page
Loading...
