Figure 14: End-to-End Procedure
Figure 15: End-to-End Procedure
• (Optional) Check the Software and Install a New Version, on page 51
• Pre-Configuration Using the CLI, on page 57
• Pre-Configuration Using the Device Manager, on page 53
CLI or Device
Manager
(Central admin)
Install the firewall. See the hardware installation guide.Physical Setup
(Branch admin)
Cable the Firewall, on page 63.Physical Setup
(Branch admin)
Cisco Firepower 1010 Getting Started Guide
50
Threat Defense Deployment with a Remote Management Center
End-to-End Procedure
To Next Page
Loading...
