46
Figure 24 Removing the Power Connectors from the Switch
6. On the power connector, insert the exposed part of the positive wire into the connection labeled “+” and the exposed
part of the return wire into the connection labeled “–”. See Figure 25 on page 47.
Ensure that you cannot see any wire lead. Only wire with insulation should extend from the connector.
Warning: An exposed wire lead from a DC-input power source can conduct harmful levels of electricity. Be sure that
no exposed portion of the DC-input power source wire extends from the connector(s) or terminal block(s).
Statement 122
1 Power connectors
16TC
±12/24/48
0.5-3.0A
332224
1
To Next Page
Loading...
Need help?
General