EasyManuals Logo

Cisco Linksys SPA3102 User Manual

Cisco Linksys SPA3102
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
Voice Gateway with Router
11
Chapter 4: Getting Started
Configuring the Voice Gateway
Configuring the Voice Gateway
1. Launch the web browser on the PC.
2. Enter 192.168.0.1/advanced in the Address field (192.168.0.1 is the default local IP address of the Voice
Gateway). Then press the Enter key.
3. If your Internet Telephony Service Provider (ITSP) did not supply a password, you will not see a login screen.
Proceed to step 4.
If your ITSP supplied a password, you will see a login screen. In the User Name field, enter user, the default
user name for user access (this cannot be changed). Then enter the user password supplied by your ITSP.
4. The Router - Status screen will appear. Click the WAN Setup tab.
5. Proceed to the appropriate instructions for your Internet Connection Type.
DHCP
a. Select DHCP from the Connection Type drop-down menu.
b. If you use a cable modem, you may need to configure the MAC Clone Settings. (Contact your ISP for
more information.)
Enable MAC Clone Service. If your service uses a specific PC MAC address, then select yes from the
Enable MAC Clone Service setting. Then enter the PC’s MAC address in the Cloned MAC Address field.
c. Click the Submit All Changes button.
Figure 4-7: Router - WAN Setup Screen
Figure 4-8: MAC Clone Settings
Figure 4-6: Login Screen

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Linksys SPA3102 and is the answer not in the manual?

Cisco Linksys SPA3102 Specifications

General IconGeneral
BrandCisco
ModelLinksys SPA3102
CategoryGateway
LanguageEnglish

Related product manuals