Cisco MDS 9000 Series

1-3
Cisco MDS 9250i Multiservice Fabric Switch Hardware Installation Guide
OL-29583-01
Appendix 1 Rack Installation
Installing and Removing the Brackets
Before Installing the Rack-Mount Support Brackets
Before installing the rack-mount support brackets for the Cisco MDS 9250i switch, check the contents
of your kit. Table 1-1 lists the contents of the optional shelf bracket kit.
Installing and Removing the Brackets
This section provides information on how to install and remove brackets.
Before installing the shelf brackets, check the contents of your kit. Table 1-2 lists the contents of the
optional shelf bracket kit.
Required Equipment
You need the following equipment for this installation:
• Number 2 Phillips screwdriver
• Tape measure and level (to ensure shelf brackets are level)
Table 1-1 Contents of Shelf Bracket Kit
Quantity Part Description
2 Bottom support brackets
20 12-24 x 3/4-in. Phillips screws
20 M6 x 19 mm Phillips binder-head screws
Table 1-2 Contents of Shelf Bracket Kit
Quantity Part Description
2 Slider brackets
2 Shelf brackets
1 Crossbar
2 10-32 x 3/8-in. Phillips pan-head screws
16 12-24 x 3/4-in. Phillips screws
16 10-24 x 3/4-in. Phillips screws