Cisco MDS 9000 Series Hardware Installation Guide

If you do not order a power cord with the system, you are responsible for selecting the appropriate power cord
for the product. Using a noncompatible power cord with this product may result in electrical safety hazard.
Orders delivered to Argentina, Brazil, and Japan must have the appropriate power cord ordered with the
system.
Caution
Standard Power Cords
Cisco standard power cords for the switch have an IEC C15 connector on the outlet end of the cord and a
country specific plug on the inlet end of the cord.
The following table lists the supported power cords and power plugs for the switch:
Table 13: Supported Power Cords and Power Plugs
Power Plug Reference
Illustration
LengthSource Plug
Type
Power Cord Part
Number
Locale
8.2 ft (2.5 m)IRAM 2073 plug
(10 A)
CAB-9K10A-ARArgentina
8.2 ft (2.5 m)SAA/3 plug, AS
3112-1993 (10
A)
CAB-9K10A-AUAustralia
8.2 ft (2.5 m)GB1002 (10A)CAB-9K10A-CHChina
8.2 ft (2.5 m)VIIG Plug, CEE
(7) VII (16 A)
CAB-9K10A-EUEurope
14 ft (4.27 m)SI 32 Part 1.01
(16A)
CAB-9K10A-ISRIsrael
8.2 ft (2.5 m)1/3G plug, CEI
23-16 (10 A)
CAB-9K10A-ITItaly
8.2 ft (2.5 m)CEE 7 Standard
Sheet VII (16A)
CAB-9K10A-KORKorea
Cisco MDS 9148V-K9 Switch Hardware Installation Guide
54
Cable and Port Specifications
Standard Power Cords

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available