Cisco MDS 9148V-K9 - Page 22

62 pages

To Next Page

To Previous Page

Cisco MDS 9148V-K9 Switch Hardware Installation Guide

Cabinet and Rack Installation

Requirements Specific to Solid-Walled Cabinets

Main Page

Table of Contents3
Audience7
Document Conventions7
Preface7
Obtaining Documentation and Submitting a Service Request8
Related Documentation8
Chassis Components11
Overview of Cisco MDS 9148V-K9 Switch11
Front View12
Rear View13
Leds14
Fan Modules17
Power Supplies17
Cabinet and Rack Installation19
Cabinet and Rack Requirements19
General Requirements for Cabinets and Racks19
Reference Perforated Cabinet20
Requirements Specific to Perforated Cabinets20
Requirements Specific to Solid-Walled Cabinets20
Cisco MDS 9000 Series Telco and EIA Shelf Bracket23
Installing the Cisco MDS 9148V-K9 Switch23
Preinstallation23
Before Installing the Shelf Brackets24
Shelf-Installation Guidelines24
Airflow Considerations26
Connection Guidelines for AC-Powered Systems26
Installation Guidelines26
Preinstallation Guidelines26
Unpacking and Inspecting the Switch27
NEBS Compliance28
Installing the Switch29
Installing the Switch in a 4-Post Rack29
Installing the Switch into a 2-Post Rack33
Grounding the Switch36
Installing and Removing Components37
Installing the ESD Grounding Strap37
Installing and Removing Power Supply Units39
Installing Power Supply Units39
Installing and Removing Fan Modules40
Removing Power Supply Units40
Installing a Fan Module41
Removing a Fan Module41
Connecting the Cisco MDS 9148V-K9 Switch43
Preparing for Network Connections43
Connecting the Console Port44
Connecting the Console Port to a PC44
Connecting a Modem to a Console Port45
Connecting the Management Ports45
Connecting to a Fibre Channel Port46
Installing a Cable into an SFP Transceiver46
Removing and Installing Cables into SFP Transceivers46
Removing a Cable from an SFP Transceiver47
Installing an SFP Transceiver48
Removing an SFP Transceiver48
Removing and Installing SFP Transceivers48
Maintaining SFP Transceivers and Fiber-Optic Cables49
Powering up the Switch49
Switch Specifications51
Technical Specifications51
General Power Supply Specifications52
Power Specifications52
Component Power Requirements and Heat Dissipation53
Power Supply Requirement Specifications53
Appendix A Cable and Port Specifications55
- Cables and Adapters55
- Console Port56
- Console Port Pinouts56
- Connecting the Console Port to a Computer Using the DB-25 Adapter56
- Connecting the Console Port to a Computer Using the DB-9 Adapter57
- Out of Band Ethernet Management Port57
- Supported Power Cords and Plugs59
- Standard Power Cords60
- Jumper Power Cords61
- Fibre Cable Specifications62

Cisco MDS 9148V-K9 - Page 22

Table of Contents

Related product manuals